Ran pipework for new shower and didn’t realise the void was so shallow but found these and they fitted perfectly, no leaks under pressure.
Great protect, normally I would use solider joints, but it easier give the positioning of the pipe , to use this push fit, as it in the under floor cavity, needed to rodent proof just in case!! You need to measure correctly and mark the pipe so you know it’s pushed correctly.
Once you place it in, it doesn't come off or leak. Perfect
Excellent elbow fitting for live water situations on coper pipes, pre siliconegrisa makes easy for installation.
yes i will recommend
Not cheap, but useful in difficult corners. The big plus is that it can be disconnected if needed. Used it on central heating where a previous soldered joint had proved dry. Resoldering would have proved difficult hence this. I did take care to rigorously clean the pipes before joining though.
Pushfit 15mm elbow. Quite cheap but a rough and sharp finish to the body of fitting. Should have gone back to shop but didn't have time.
Easy to use, when you don't have a gas soldering available and cheaper than compression fittings
Quick, secure, watertight, tough and removeable.
Very easy to use in those places where you cant get a blow torch in, or just need something for speed.
But make sure that your pipe is cleanly cut, undamaged, and deburred nicely.
Easy to fit and release. Nicely made and slim design
Excellent piece of kit easy to use and no drips fabulous
