It's a finger plate, it does the job. Not much else to say
Stops dirty fingers marking the paint work
Product is fine, downgraded rating as the protective film didn't only covered around 75% on the plate and there was a little damage on the exposed part. Otherwise the product was ok.
This 1 Star rating was only given to access comments for this product review. The push plate has 6 X pre-drilled counter-sunk holes for screw fixing. No c/s screws are included. Fix points are at the TOP, CENTRE and BOTTOM for a vertically mounted plate measuring 350x75mm. The corners are rounded off to an 8mm radius......These are ACTUAL centre to centre measurements to all pre-drilled holes..........Corner TOP HOLES - L Side; 10.5mm in from L side edge and 13mm down from TOP edge......R Side; 11mm in from R side edge and 11.5mm down from TOP edge..........CENTRE HOLES - L Side; 11.5mm in from L side edge and 176mm down from TOP edge......R Side; 12mm in from R side edge and 176mm down from TOP edge..........Corner BOTTOM HOLES - L Side; 14mm in from L side edge and 13.5mm up from the BOTTOM edge ......R Side; 13.5mm in from R side edge and 14.5mm up from the BOTTOM edge. Not one hole is in true alignment with any other, with the exception of the centre horizontal holes. However, they too have been drilled off-centre in the plate at 176/174mm (350mm). Shoddy out-of-square production. Where is quality checking and control?
Dood product & reasonable price. SAervice good
not yet used but seems of good quality
The push plate is of reasonable quality, however no screws where supplied to have the same finish. Bit dissapointing, as I don't normally carry such a small screw, only needed 6 of them, had to buy a box of about 100!!!
Look great for the price and worth every penny
Good quality great finish too . not used for its proper purpose by myself I use them for model building
