Well, it works. But it’s very expensive for a piece if moulded plastic. I was able to buy 10 stainless steel equivalents for under £10 elsewhere. Toolstation doesn’t seem to be any more expensive for this Speedfit item as other suppliers, so I assume that the cost is down to the manufacturer.
Average. Extremely hard to get the pipe in the former and if its cold it just pops out.
Ideal. Saves a lot of time
No good for the grey plastic pipe I was using. It kinked every time I tried to insert it.
Needed to keep a tight radius on 2 bends and this did the job. Difficult to force the bend with the pipe cold though so I used an electric paint stripper gun to warm the pipe up first.
Brilliant, but you do need to carefully install them. I used a number of these but still managed to crease one of the pipe turns. It was quite a cold day, so possibly that was a contributing factor. They just allow you to get a really tight bend that stays in place.
Hard to find elsewhere in this size. Not cheap but the right way to take a corner without loosing flow.
