| Brand | Fischer |
| MPN | 523226 |
| Type | 10 Minute Epoxy |
Used or brick stitching on a single brick wall. Did the job well, but you don't have to hang about as the resin sets hard in just a few minutes. I used the same resin for brick stitching on another wall 2 years ago and the wall has been perfect since then.
Used for first time after trying several mechanical fixings to hang a bathroom sink/cupboard off a drywalled thermalite block wall. Worked a treat using 10mm threaded studs, easy to prep and use the resin. Highly recommend where you may be struggling to anchor and want confidence.
Brill. Even though the resin set hard in the nozzle after use, the resin in the tube was still absolutely useable for days and use it I did.
Easy to use from a standard gun and extremely strong hold.
Does the job and the studs are holding fast in damp conditions.
I used this for filling cracks in rendering. Easy to use, smoothed out neatly to leave good finish and seemed to set as hard as stone. Bought extra nozzle as warned it can go off very quickly. Too expensive to waste needlessly. Good stuff. Well worth the cost.
Works very well - you must wear gloves though as thigs can become a bit messy.
I love this stuff. It bonds to almost anything. Works as an anchor for threaded bar rods but works equally well to fill cracks in concrete as well as a super strong bonding agent. It does have a fairly short work time and you should always wear hand protection...it is seriously hand to remove from your skin. Fairly expensive but worth the money if used in the right way
Sets harder than concrete, yes I couldn’t believe how hard it sets and so simple to use and cheaper than building supplies companies.
Great product. Seems to bond to a super strength and easy enough to apply with some forward planning. However the instructions on the tube are hard to fathom and more detailed instructions are not easy to combine online. Meanwhile the product seems to be intended for single use. That said, if you carefully scrape out the inside of the tube and replace the cap it seems to last.
Make sure you pick up the nozzle that should accompany the tube (as a bundled product).
Great resin, but unfortunately I bought it from somewhere else because of Toolstation's useless programming. They sent an email saying it was ready to collect. It wasn't, so I wasted a journey. Nobody knew when it might arrive for collection. They said they would email when it was actually ready. They never did, so I cancelled the order.
Very good stuff, done the job perfectly.
This stuff is amazing. Make sure you clear the hole from any dust and you can't use half a tube and store it for later use because once the two ingredients mix, they react and go rock solid so the nozzle will be rock solid the next time you come to use it. But this does come with two nozzles.
Purchased two tubes. One was over a year out of date and the other six months out of date. Staff seemed unaware of the requirement to be in date, but refund obtained without any problem
Very easy to use anchor resin. I used to "glue" some stainless steel threaded bar into a concrete fence post. It even came with a nozzle, which surprised me! I used it with the Fischer gun which I purchased 18 months ago.
Quality product that does the job it is meant to do.
