Would have been nice to have a blank with it. Other than that it's fine.
Could do with a neutral bar and rear cutouts but excellent othereise
Basic and does the job. Accurate position of din rail and face cutout complies with IP requirements of BS7671. Take care on removing knockouts as this could potentially damage the casing. Make sure earth bar is secure to case.
This enclosure is robust and perfectly suitable for the job in hand. The only downside was the lack of blanking plates. I would have expected to get a couple with it. As it was I had to search the bottom of my toolbox and fit an old one (and it shows). Apart from that, no issues.
Good budget enclosure. Does the job. Reasonably sturdy.
Great unit with plenty of height inside for cables, good value as well
Not bad for the money. You can’t drill into the side to bring cables inside, as the sides are part of the removable front cover. Other than that good.
Good enclosure but no knock outs for cable entry, and no stickers to label up anything.
bought as a quick temporary fix to have some power while doing a large cu change and just had a couple of sockets on an RCBO on a temp board, although not too bad to work with, I only purchased as it said in description that it had an earth stud and earth/neutral bar. the bar is bolted to the casing and NOT separate. Not a problem for me as I was only using as a temp solution so came straight out of main sw with my N but joe blogs who's doing his own garage install would probably not have noticed.
