Making cutting through very quick and easy. Very good value for money
Worked but very wobbly. They Arbor Fitting in the centre was not a good fit. There's a lot of movement and it doesn't cut a particularly accurate 127 mm hole.
I bought this to fit 125mm ducting through some kitchen cabinets. Cuts very well but the 125mm rigid duct is too large for the 127mm hole. Some extra work was required to fit rigid 125mm ducting, probably OK with the flexible version.
Only using it for cutting holes in plasterboard for down lighters so have not tried it out on metal, but great for what I use it for.
Fits mandrill ok and holes locate as they should.
Simple and easy, cut into soffit with easy. Clean and tidy, so simple anyone can do it.
Cutting holes in some sheet metal wrapped suspended floor tiles for power grommets. Purchased two which managed two holes before blunt. So if you one needs one hole great, if not perhaps opt for another brand. Don't think these would manage any holes in sheet stainless.
Really good quality at a great price, wish I'd bought one years ago. Makes short work of putting 100mm ducting holes in wood or plastic, used it for putting a vent in my shed.
Did a good job at drilling holes of 70mm size and does so easy.
Used to cut through metal shelving. Well impressed.
Nothing spectacular, but good value and at cost can be disposed/replaced cheaply once it has reached the end of it`s useable work life
does a clean cut through wood without worries, slightly short so careful if going in deep
Nice quality piece of kit. My only criticism would be that, whilst the current is threaded to receive the shaft, if you tighten it up the two locator pins don’t match the holes. So, to match the holes with the pins you have to loosen it which means it is wobbly when cutting. Poor design.
Great price, in stock, fits standard mandrel, just the job
Worked as it should for the job that i needed it for
Great for the price. Did what it was supposed to do with no effort.
I’ve used it to cut 4 holes in 3mm mild steel sheets and it’s still cutting well so I think it has a few more holes left in it. Cuts nice holes with not much burr
You get what you pay for. there's a reason why it's cheap. only really good for 1 use. got blunt almost after i did my cut. Didn't bother using it a second time.
Used for the desired outcome, yep, it cuts holes… it will no doubt cut more holes when needed.
Worked reasonably well for the price, will not lock down tightly to the arbour so vibrates quite a bit.
Great value for money. Good quality and they last.
